TouellSkouarn Strakal Orsel, Справочник по сборке

Страница: 1 / 11

Page 1
Strakal Orsel Build Document v1
Your solder joints should look like those shown as ‘OK’ below, they should have that neat
conical shape on BOTH sides of the PCB. If they don’t look the same on both sides then stop!
Work out why from the soldering guides linked and don’t continue until you are getting those
results. This isn’t about perfectionism, you are very likely to end up with a destroyed, damaged
or defective unit if you’re not hitting that standard.
This photo is from the Adafruit guide to excellent soldering -
​ http://bit.ly/1l77tF4 ​ and is
reproduced under an Attribution-Sharealike creative commons license -
http://creativecommons.org/licenses/by-sa/3.0/
Start off by soldering the resistors and diodes
2 220k R1, R3
5
1M
R2, R4, R8, R12, R14
1
150k
R10
2 100R R5, R6
1
300k
R7
1 10R R9
1 33k R11
1
220R
R13
1 4.7k R15
You might have a spare 1M resistor in your kit - this is unused.
4 1N4148 D3, D4, D5, D6
(SEE IMAGE FOR CORRECT POLARITY!)