Changing / Adding 10W Oil
1. Turn the lubricator retaining ring counter-clockwise by hand, then lower the
bowl/housing away from suction wick. (pic 1)
2. Add 10W tool oil (or equivalent) until level with fill line. (pic 2)
3. Be sure that the O-ring is properly seated in the top of the lubricator bowl. (pic 3)
4. Reinstall the bowl/housing into place. Hand tighten only. Do not over tighten. (pic 4)
Checking / Adjusting the Drive Chain Tension
1. Use a 5/32” hex key wrench to loosen two screws located at the top of the motor/chain
guard. Do not remove the screws. (pic 1)
2. Gently tilt the unit forward and remove third screw located at the bottom of the guard.
(pic 2)
3. Remove the chain guard to reveal drive chain. (pic 3)
4. Apply pressure to mid-span point. Movement should not be more than 3/32”. (pic 4)
5. If tension adjustment is necessary, loosen the two upper hex screws on the motor
mounting plate. (pic 5)
6. Locate the drive chain adjustment screw at the very top of the motor mounting plate.
(pic 6)
(continued)
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
P
P
H
H
X
X
-
-
1
1
5
5
0
0
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
Page 19
Pic 1
Pic 2
Pic 3
Pic 4
Pic 1
Pic 2
Pic 3
Pic 4
Pic 5
Pic 6
