Phoenix 4400- DHP
November 2017
24
24. Threading Pressure Sensitive (PSA) Film
1.
Raise the gap adjustment handle to the 1/4” (Open) position.
2.
Put the roll of over laminate on the PSA supply shaft.
3.
Pull the top film web under the top idler bar and bring it up to the release liner rewind shaft.
4.
Attach the film with liner to the rewind tube with a piece of masking tape.
5.
Separate the film from the liner and drape the film over the top roller.
6.
Thread the bottom roll of printed media or Kraft paper behind the bottom idler bar and bring it
up to the bottom roller. If using mounting adhesive DO NOT go behind the bottom idler bar,
(as shown above).
7.
Push the bottom roll of substrate through the rollers, flatten against the roller and tape to the
back deck.
1.
PSA film supply
2.
PSA release liner rewind
3.
Release liner
4.
Top idler bar
5.
Top Roller
6.
Bottom roller
7.
Bottom substrate: can be Printed
media, mount adhesive or Kraft
paper, (use the bottom thermal
film supply shaft)
8.
Bottom idler bar
9.
Pull rollers
10.
PSA film
1
2
4
5
6
7
8
9
3
10
Gap adjustment handle
in the OPEN position