— 8 —
Setting the Video Channel
This VCR is designed to send picture and sound signal on UHF channel E36 to the TV, through the RF coaxial cable.
If you want to change this video channel (E36) to another channel (between E28 to E60), follow the procedure below
before turning on the VCR for the first time.
1
Make sure the VCR is turned off and no cassette inserted.
2
Turn on the TV, and tune it to any channel (UHF E28 to E60) you want to use as the video channel on the TV.
• Select a channel not used in your area.
3
Press
STOP/EJECT
7
/
0
on the front panel for more than 5 seconds.
The following indication appears on the display.
4
Press
CH
5 / ∞ on the VCR to select an appropriate TV system number for your area.
1. For B/G. (For West Europe, ASEAN countries, New Zealand)
2. For D/K. (For China, Russia, East Europe)
3. For I. (For Hong Kong, South Africa, United Kingdom)
5
Press
OK/STATUS
.
The channel number starts flashing on the display.
6
Press
CH
5 / ∞ on the VCR to select the channel you have tuned on the TV as the video channel in step 2.
A test signal (two vertical white bars) appears on the TV.
7
Press
OK/STATUS
to finish the video channel setting.
Now you will enter the Initial Setup mode explained on page 9.
To watch a picture from this VCR on the TV, select the same channel you have selected as the video channel (in step 2
above) on the TV.
TV system number starts flashing.
Test signal
(two vertical white bars)
Channel number starts flashing.
S
ETTING
U
P
If you use only external video input (AV) mode to
watch the picture from this VCR, you can turn off
the video channel output. To turn off the video
output channel, press
CH
∞ until “– –” appears on
the channel number position.
vr210/410/55
00.3.6, 1:08 PM
8
