Philips VL3015 Spot Luminaire, User Manual

Page: 107 / 118

T
ROUBLESHOOTING AND
M
AINTENANCE
A
0 2 . 9 6 7 9 . 0 0 0 2 A 2 7 A u g u s t 2 0 1 3 89
Reflector Change
The VL3015 Spot and VL3515 Spot luminaires come with both a Peaked and Flat Field Reflector.
Users can choose between either reflector as desired.
Note: The unit, when shipped from the factory, has the Peaked Reflector installed in the unit’s hot
box and the Flat Field Reflector stored in the luminaire head assembly underneath the bottom head
cover.
Tools:
#2 Phillips and Flat screwdrivers
WARNING: Remove power from luminaire before performing maintenance. Reflectors will be
extremely HOT after operation. Allow to cool before removing and replacing.
CAUTION: Do not touch reflectors with bare fingers. Wear cotton gloves or other covering while
removing and replacing. To clean, refer to “Cleaning Optics, Filters and Gobos” on page 92 .
To change the reflector:
Step 1. Remove power from luminaire.
Step 2. Place luminaire on enclosure on a flat and steady work surface.
Step 3. Rotate head so bottom head cover is facing up. Bottom head cover is determined by the
orientation of the back cap text. When the text is in the correct orientation, the bottom head
is the lower head cover.
Step 4. Remove bottom head cover by loosening four 1/4-turn screws as shown in Figure A-5 .
Figure A-5: Bottom Head Cover Removal
Bottom Head Cover *
1/4-Turn Screw (4 ea.)
CAUTION:
* Bottom Head cover is attached by tether.
Luminaire and reflector will be extremely hot
after operation. Allow luminaire to completely
cool and wear protective gloves.