English
Troubleshooting
Stations react when you operate
Center’s remote control
x flashes on the sychro display of Center’s
remote control
After the set is switched on, nothing
appears on the sychro display of Center’s
remote control
The remote control does not function
properly.
CD
“No Disc”/ “Cannot read CD” is
displayed
Sound cannot be heard or is of poor
quality.
The disc skips tracks
Sound skips during MP3/WMA playback
✔
Center’s remote control is powerful enough to
operate several Stations within certain distance
or angle. Check you have placed the Stations in
different rooms or place Stations in different
angles
✔
Use Station’s remote control or the controls on
the set.
✔
Signal error. Check you have pointed the remote
control toward the IR area of the set you wish
to operate
✔
You switched on the set by using the control on
the set instead of center’s remote control.
Press
REFRESH
on center’s remote control to
synchronize its display.
✔
Remove the protective plastic tab before using
the Station’s remote control.
✔
Reduce the distance between the remote
control and the set.
✔
Insert the batteries with their polarities
(+/– signs) aligned as indicated.
✔
Replace the batteries.
✔
Point the remote control directly towards the IR
sensor.
✔
Insert a suitable disc.
✔
Check if the disc is inserted with graphics facing
front
✔
Wait until the moisture condensation at the lens
has cleared.
✔
Replace or clean the disc, see “Maintenance”.
✔
Use a finalized CD-RW or CD-R.
✔
Adjust the volume.
✔
Disconnect the headphones.
✔
Switch off MUTE.
✔
Replace or clean disc
✔
Switch off SHUFFLE
✔
MP3 file made at compression level exceeding
320kbps. Use a lower compression level to rip
audio CD tracks.
✔
Replace or clean disc.
WACS5_Eng/37
8/3/2005, 15:13
44
