Philips SH3L 170X4, Service Manual

Page: 27 / 71

170X4 27
Go to cover page
ISP CABLE for CPU GM5120BD
Step 6 :
And entering factory mode to check CPU version as shown
in Fig. 5.
It is have to Re-connecting the main code After Finished,
Troubleshooting :
Monitor : Monitor is on (LED is green.), or off,
but no display (black)
1. Make sure to disconnect the mains cord at Monitor ,
then connect it again.
2. EEPROM size may be not correct.
Fig. 5
Step 1 : Make a folder in your PC as shown in Fig. 2.
For example : C:\170X4.
Step 2 : Copy ISP Software (170X4.zip) into your folder as
shown in Fig.2.
Step 3 : Unzip isp.zip into your folder as shown in Fig. 2.
Step 5 : Execute ISP Software in Monitor (A) as shown in Fig. 4.
Step 5-1.=> C:\cd 170X4 ( as shown in Fig. 4-1).
Press "Enter" key on keyboard, bring up Fig. 4-2.
Step 5-2.=> Key in "Gdd" Press "Enter" key on keyboard, bring up Fig. 4-3.
Step 5-3.=> Key in "BDISP.txt" ,Press "Enter" key on keyboard again, bring up
Fig.4-4.
Step 5-4.=> Key in "exit" ,Press "Enter" key on keyboard again, bring up
Fig.4-5.
Step 4 : Connect ISP cable and Mains cord to Monitor
as shown in Fig. 3.
Fig. 4
Configuration and procedure
ISP (In System Program) software
ISP cable
is provided by Genesis to upgrade
the firmware of CPU.
is for the interface between "Parallel Port of PC" and
"15 pin-D-SUB connector of Monitor".
It is a DOS-based program, which cannot be run in MS-Windows.
System and equipment requirements
1. An i486 (or above) personal computer or compatible.
2. Microsoft operation system Windows 95/98
=>
.
4. ISP Cable (3138 106 10148) as shown in Fig. 1
DOS environment
3. ISP Software
Fig. 1 => ISP CABLE : 12nc is "3138 106 10148".
Fig.3
PC
T
o
printer
port
(L
TP1)
T
o
video
card
Video cable
Connect to
Mains cord
Monitor (A)
Monitor (B)
ISP cable
D-Sub
25 pins
Connect to Mains cord
at this moment.
------------------------------->
Fig. 2
Fig. 1
<== 4-1
<== 4-2
<== 4-3
<== 4-5
<== 4-4
-----------------
-------------------------------------
HUDSON 170X4 V200 2003-09-23