6
During assembly
•
Make sure that the wiring is properly dressed as
in the original situation. When replacing crimp
connections or tie wraps, perform a pull test.
Prevent entrapment of wiring between housing-
or internal parts.
•
Make sure that all parts are re-assembled, and
that no parts are forgotten. E.g.: sleeves, internal
protection caps, screws.
•
Make sure that the housing parts are properly
assembled. No gaps should be present, yet
make sure screws are not overturned.
After assembly:
•
Check all relevant functions of the appliance.
•
Check if the consumer complaint has been
resolved.
•
Check for abnormalities. E.g.: leaking liquids,
smoke, smell, abnormal noise.
•
Check the use safety functions. E.g.: lid-open
detection switch, motor disable switches.
•
Check the electrical safety functions:
- leakage current
- high voltage (servicer to perform a test)
- earth continuity (servicer to perform a test)
Disassembly information
To remove the brew chamber lid cover handle as
follows:
•
Place the screwdriver on
the positions (see
picture 1) and lift the
cover over the snap
locks on both positions.
•
The cover lid can now
be lifted up a little and
to remove the complete
cover including lever
and push rod squeeze
strongly with two fingers
both legs of the push
rod (see picture 2) to
each other, so that the
two pins will get out of the hinge position on the
brew chamber.
•
To remove lever from lid cover, take a screwdriver
and bend carefully the two lips/ribs in the lid
cover outwards and push the lever with force out
of the hinge.
•
Reassemble follow steps backwards, without
using a screwdriver.
To remove the back cover handle as follows:
•
Remove valve outlet.
•
Start at the upper side of the back cover
and stick a screwdriver into the 2 snap locks
positions and gently pull the back cover from
the appliance so that a little chink between back
cover and brew chamber becomes visible.
•
Put the screwdriver in to the 4 rectangular holes
(snap locks) at the back and gently pull the
screwdriver such away that the lips of the snap
locks are bent outwards.
•
If all clicks positions are loose, it is possible to
remove the back cover.
•
Reassemble follow steps backwards.
picture 1
picture 2
Disassembly- and Reassembly advice
