3
IMPORTANT!
This Baby Monitor is intended as an aid. It is not a substitute for responsible and proper adult
supervision and should not be used as such.
Make sure the Baby unit and adapter cable are always out of reach of the baby, at least 1 metre away.
Never place the Baby unit inside the baby’s bed or playpen!
The antennas on the Parent and Baby units are fixed; do not try to extend them.
Never cover the Baby unit (with a towel, blanket, etc.)
C
ONGRATULATIONS
You have just purchased a high-performance, cordless Baby Monitor that lets you listen to your child
from wherever you are in and around the house. Please read this guide carefully before using the
monitor, and keep it for future reference.
G
ETTING
THE
UNITS
READY
FOR
USE
Baby unit
Connect the AC power adapter (A–9) to an AC mains socket, and then connect the cord to the DC
power supply socket (A–5) of the Baby unit.
If you want to use batteries, remove the battery compartment cover (A–8) using a screwdriver. Insert
four 1.5V, AA batteries (not included; we recommend non-chargeable Philips Alkaline batteries), noting
the + and - configuration inside the battery compartment. Put the cover back in place and tighten screw.
The Baby unit operates cordlessly for up to 30 hours on fresh batteries. The red
POWER
light (A–1)
flashes when battery power is low. If this happens install new batteries.
Note
: To switch off the Baby unit completely set the mode switch (A–6) to
OFF
.
Parent unit
The Parent unit uses rechargeable batteries. These are already installed, but first they must be charged
for at least 14 hours as follows before using the unit outside the charging base:
• Connect the AC power adapter (B–10) to an AC mains socket, and then connect the cord to the DC
power supply socket (B–9) of the charging base (B–5).
• Place the Parent unit inside the charging base. The red charging light (B-11) lights.
The Parent unit can be operated now but you should leave it in the charging base until the batteries are
fully charged (at least 14 hours). When the batteries are fully charged, take the Parent unit out of the
charging base and use cordlessly for up to 12 hours.
When the red
POWER
light (B–1) on the Parent unit flashes, the battery power is low. Place the Parent
unit inside the charging base to recharge the batteries.
If the rechargeable batteries begin to lose their effectiveness, replace them with four new batteries
(1.2V, AA NiMH) as follows: remove the battery compartment cover (B–6) using a screwdriver and
insert the batteries noting the + and - configuration inside the battery compartment. Put the cover back
in place and tighten screw.
Only use 1.2V, AA NiMH rechargeable batteries!
