Page
6
of
33
Using the USB Cable and Computer
1. Locate the USB cable and connect the small flat end into the
back of the charging station.
2. Plug the larger flat end of the cable into the USB port on the
front of the computer.
3. The Recorder is in the OFF position.
4. Insert the recorder into the docking station. The bottom of the
recorder slides down, press firmly until it locks into the docking
station.
5. The green LED lights up indicating fast recharge mode. The Recorder display
indicates ‘Charging’.
6. Recharging is complete (about 2.5 hours) when the green LED blinks on and off.
Note: You do not have to use the docking station when charging to the computer. Just
plug the small flat end into the bottom of the recorder. When connected to the
computer you will not be able to record.
Activate Recorder
1. Turn recorder on by sliding the ON/OFF switch to the ON position.
When turning ‘On’ the recorder for the first time you will be prompted to set the
‘Language’.
2. The language will already be selected and highlighted (INT) for international
language.
3. Look at the recorder display for
OK
and press the corresponding smart button.
Next the recorder will prompt you to set the date and time.
4. Press the
+
plus or
–
minus buttons to change the value for the year, month, day
or time settings.
5. Press the corresponding smart buttons to advance to the
left or right
of the
entry.
6. Press the
+
plus or
–
minus buttons to select a 12 hour (non-military) or 24 hour
clock (military time).
7. If a 12 hour clock is selected set the AM or PM settings.
8. The display window will show
OK
in the middle press the [Menu] button to
accept your changes.
9. If you make a mistake and need to change your settings then press the [Menu]
button.
10. Press the
+
plus or
–
minus buttons to scroll to ‘Setup’ then press the [Menu]
button again or the [Enter] smart button to get into the Setup submenu.
11. Press the
+
plus or
–
minus buttons to scroll through the menu list. Locate the
‘Date/Time’ then press the [Menu] button again or the [Enter] smart button to get
into the ‘Date/Time’ settings.
12. Once the Date/Time settings are correct then press the [OK] smart button to
save settings.
