EN 34
Reset picture and sound
You can restore the default picture and
sound settings, while the channel installation
settings remain the same.
1. While you watch TV, press .
2. Select
[Setup]
>
[TV settings]
>
[General
settings]
>
[Factory settings]
, then press
OK
.
3. Select
[OK]
, then press
OK
.
All TV settings (except for channel settings)
are reset to the default factory settings.
Channels
Automatic installation
When the TV was switched on for the first
time, a full installation of channels was
performed.
To change your language, country, and
reinstall all available TV channels, you can run
this full installation again.
Start installation
Note:
If you are prompted to enter a code,
enter '8888'.
1. Press .
2. Select
[Setup]
>
[Search for channels]
>
[Reinstall channels]
, then press
OK
.
3. Select your country, then press
OK
.
4. Select your network, then press
OK
:
[Antenna (DVB-T)]
: Access free-to-air
antenna transmissions.
[Cable (DVB-C)]
: Access cable
transmissions.
5. Follow the onscreen instructions to select
other options, if any.
The start menu for channel search is
displayed.
6. Select
[Start]
, then press
OK
.
7. Once the channel search is complete,
select
[Finish]
, then press
OK
.
Tip:
Press
LIST
to see the channel list.
Note:
When digital TV channels are found,
the list of installed channels may display
empty channel numbers. You can rename or
reorder these channels.
Install analog channels
You can search and store analog TV
channels one by one.
Step 1: Select your system
Note:
Skip this step if your system settings
are correct.
1. While you watch TV, press .
2. Select
[Setup]
>
[Channel settings]
>
[Channel installation]
.
3. Select
[Analogue: Manual installation]
>
[System]
, then press
OK
.
4. Select the system for your country or
region, then press
OK
.
Step 2: Search and store new TV channels
1. While you watch TV, press .
2. Select
[Setup]
>
[Channel settings]
>
[Channel installation]
.
3. Select
[Analogue: Manual installation]
>
[Search channel]
, then press
OK
.
4. Find the channel:
If you know the channel frequency,
enter it with the
Navigation buttons
or
Numeric buttons
.
If you do not know the channel
frequency, search for the next
frequency that has a strong signal.
Select
[Search]
, then press
OK
.
5. After you find the correct channel, select
[Done]
, then press
OK
.
6. Select
[Store as new channel]
, then press
OK
to store the new TV channel.
Note:
If the reception is poor, reposition
your antenna and repeat the procedure.
