English
35
Clock/Timer
Clock setting
See "Preparations-Step 2: Setting the clock".
Timer setting
●
The system can be used as an alarm clock,
whereby DISC, USB or TUNER is switched on at a
set time (one time operation). The clock time
needs to be set first before the timer can be used.
1
In standby mode, press and hold
SLEEP/
TIMER
on the remote control for more than
three seconds.
➜
"
SELECT SOURCE
" is displayed briefly.
2
Press
DISC
,
USB
or
TUNER
to select your
desired source and press
SLEEP/TIMER
to
confirm.
➜
"
SET ON TIME
" is displayed briefly. Then, the
hour digits flash on the display screen.
●
Before setting timer, make sure the music source
has been prepared.
DISC
– load the disc.
USB
– connect a suitable USB device.
TUNER
– tune to the desired radio station.
3
Press
/-
on the front panel or
VOL
+/-
on the remote to set the hours and press
SLEEP/TIMER
to confirm.
➜
The minute digits flash on the display panel.
4
Press
/-
on the front panel or
VOL
+/-
on the remote to set the minutes and press
SLEEP/TIMER
to confirm.
➜
The timer is now set and activated.
5
In standby mode, press
SLEEP/TIMER
on the
remote control to activate or deactivate the
timer.
➜
Display shows
if activated, and disappears
if deactivated.
Sleep timer setting
The sleep timer enables the system to switch off
by itself after a set period of time.
1
In active mode, press
SLEEP/TIMER
on the
remote control repeatedly to select a preset
time.
➜
The selections are as follows (time in minutes):
OFF
™
SLEEP 90
™
SLP 80
™
SLEEP 70
™
SLEEP 60
™
SLEEP 50
™
SLEEP 40
™
SLEEP 30
™
SLEEP 20
™
SLEEP 10
™
OFF
➜
“
SLEEP XX
“ or “
OFF
” is displayed. “
XX
“
denotes the time in minutes.
2
When you reach the desired length of time, stop
pressing the
SLEEP/TIMER
button.
To deactivate the sleep timer
●
Press
SLEEP/TIMER
repeatedly until "
OFF
" is
displayed, or press
ECO POWER/STANDBY
ON
y
(or
y
on the remote)
.
2;
4
pg001-pg039_MCD149-12-Eng
2007.9.13, 15:35
35
Summary of Contents for MCD149
Page 3: ...3 7 1 2 3 4 5 6 8 9 0 4 ...
