18
English
3139 115 22741
Getting Started
Step 1: Inserting batteries
into the remote
control
1
3
2
1
Open the battery compartment.
2
Insert two batteries type R06 or AA,
following the indications (
+-
) inside
the compartment.
3
Close the cover.
Using the remote control to
operate the system
1
Aim the remote
control directly at the
remote sensor (iR) on
the front panel.
2
Select the source you
wish to control by
pressing one of the
source select buttons
on the remote control
(for example TV/AV,
TUNER).
3
Then select the desired
function (for example
2;
,
S
,
T
)
.
CAUTION!
– Remove batteries if they are
exhausted or if the remote is not to
be used for a long time.
– Do not use old and new or
different types of batteries in
combination.
– Batteries contain chemical
substances, so they should be
disposed of properly.
Step 2: Setting the clock
The clock can be set in either 12-hour or
24-hour mode ("
12
:
00 AM
" or "
00
:
00
"
for example).
CLOCK/TIMER
PROG
1
2
3
4
12
:
00 AM
00
:
00
SEARCH/PREV
SEARCH/PREV
13
:
38
13
:
38
CLOCK/TIMER
1
In standby mode, press
CLOCK/TIMER
once.
➜
"
12
:
00 AM
" or "
00
:
00
" will flash.
2
Press
PROG
to change between 12-hour
and 24-hour clock mode.
3
Press
S
/
T
to set the minutes and
hours. To increase the speed, hold down
S
or
T
.
➜
The changes in minutes will roll over
to the hours.
4
Press
CLOCK/TIMER
again to store
the setting.
➜
The clock will start working.
To view the clock time in any active
mode
●
Press
CLOCK/TIMER
.
➜
The clock will display for a few seconds.
Helpful Hints:
– If the DVD system is disconnected from
the power supply, it will erase the clock
setting.
– If you do not press any buttons within 90
seconds, the system will exit clock setting
mode.
SOUND
VOLUME
SURROUND
iR
SENSOR
buttons on
top panel
DVD system’s
display panel
001-045-LX71-22-Eng
8/07/2003, 11:26 AM
18
