Service Modes, Error Codes, and Fault Finding
EN 24
LC7.2E LA
5.
Software Upgrade Procedure
1.
Power ON your TV with the power switch at the side of the
TV. Put your TV ON by using the remote controller if the TV
is in Stand-by.
2.
Make sure that it is in “Digital” mode (via “A/D” button).
3.
Make sure that your TV is not in Stand-by. Power OFF your
TV
with the power switch of the TV
.
4.
Remove the Conditional Access Module (if any) from the
CI-slot.
5.
Insert the PC Card Adapter with the portable memory card
containing the software upgrade files.
6.
Switch ON your TV with the power switch at the side of the
TV.
7.
At start-up, the TV will scan the CI slot until it finds the
update content. The TV will automatically go to the
upgrade mode. After a few seconds it will display the status
of the upgrade procedure.
Warnings:
Do NOT remove the memory card or the PC card adapter
during the software upgrade procedure.
In case of a power drop during the upgrade procedure, don’t
remove the portable memory from the TV. The TV will continue
the upgrade as soon as the power comes back.
Example:
At start-up of the TV, the current software is erased.
Figure 5-11 Erasure of the software
If the erasure is successful, the programming will start.
Figure 5-12 Programming of the software
Example:
The programming is completed when the progress
bar reaches the 100% mark.
Figure 5-13 Programming complete
The TV will reset and the screen will go blank, after a few
seconds a dialogue box will occur to inform you that the current
module inserted in the CI slot is not recognized. This is normal
as the slot only recognizes a Conditional Access Module during
normal operation.
Example: The following dialogue box will appear after the TV is
upgraded successfully:
Figure 5-14 Upgrade ready
When the software upgrade has been successful, switch OFF
the TV, remove the PC Card Adapter, and restart the TV with
the Power switch at the side of the TV.
The TV will now start up with the new software.
Verifying that the Software Has Been Upgraded
Successfully
Verify that the software is upgraded to the new version by
following the procedure outlined in the section “Verifying the
current version of the TV software”.
5.6.3
1080p Panel SW Upgrade
To upgrade the SW on the 1080p panel:
1.
Remove the back cover of the TV.
2.
Connect the ComPair UART cable to the UART connector
on the 1080p panel (refer to next figure).
3.
Follow the instructions in ComPair.
Figure 5-15 1080p connection overview
G_16221_002.ep
s
241006
G_16221_00
3
.ep
s
241006
G_16221_004.ep
s
241006
G_16221_005.ep
s
241006
G_16
8
60_090.ep
s
150
3
07
DUAL LVD
S
FLA
S
H MEMORY
S
INGLE LVD
S
+ I2C
12V
UART