Philips Intellicare GC7020, User Manual

Page: 8 / 42

Do not put perfume, vinegar, starch, descaling agents, ironing aids, other
chemicals or 100 percent distilled water in the water tank.
C
1 Remove the detachable water tank from the steam tank.
2 Fill the water tank with water up to the MAX indication.
3 Slide the water tank back into the steam tank.
◗
The water tank can be refilled at any time during use.
◗
This appliance has a built-in water level sensor.When the minimum
level in the detachable water tank has been reached, the 'water
tank refill' indicator light goes on.
Steam ironing will not be possible!
B
Note: When you use the appliance for the first time or after Calc Clean,
a lot of water will be pumped from the detachable water tank into the
steam tank. Refill the water tank, if necessary.
Setting the temperature
1 Check the garment label for the required ironing temperature
-
1
Synthetic fabrics ( e.g. acryl, viscose, polyamide) and Silk
-
2
Wool
-
3
Cotton
- 'MAX' Linen
C
2 Set the temperature dial to the required ironing temperature
by turning it to the appropriate temperature indication.
3 Insert the plug into an earthed wall socket and set the on/off
switch to 'on'.
◗
The steam tank and the iron will now start heating up.
The iron takes approx. 1 minute to heat up to
2
and the steam tank
takes approx. 2.5 minutes to heat up.
C
◗
As soon as the steam tank has reached its maximum pressure
level and is ready for steam ironing, the steam tank pilot light goes
out.
Tips
- If the article consists of various kind of fibres, always select the
temperature required by the most delicate fibre, i.e. the lowest
temperature. If, for example, the fabric consists of 60% polyester and
40% cotton, it should be ironed at the temperature indicated for
polyester (
2
).
ENGLISH
8