- Plug power cord directly into power
outlet. Do not use an extension cord.
- Only use the power cord and other
accessories supplied with the product.
IMPORTANT
: The power plug contains a
transformer. Do not cut off the power plug
to replace it with another plug as this will
cause a hazardous condition.
SAVE THESE
INSTRUCTIONS
SPECIAL POLARIZED PLUG
INSTRUCTIONS
This product has a polarized plug (one
blade is wider than the other). To reduce
the risk of electric shock, this plug is
intended to fit into a polarized outlet only
one way. If the plug does not fit fully into
the outlet, reverse the plug. If it still does
not fit, contact a qualified electrician. Do not
attempt to modify the plug in any way.
Introduction
Congratulations on your purchase and
welcome to Philips Norelco!
To fully benefit from the support that
Philips Norelco offers, register your product
at
www.norelco.com/register
.
General Description (Fig. 1)
1 Protection cap
2 Cutting unit
3 Adjustment lever
4 On/off-switch
5 Click-on guards
6 Scissors
7 Cleaning brush
8 Clipper oil
9 Hair comb
Not shown: power cord and pouch.
Using the product
Note: Make sure your hair is clean and dry.
Do not use the product on wet hair.
Tips & tricks
- To clip in the most effective way, move
the product against the direction of hair
growth.
- Since hair grows in different directions,
you need to move the product in
different directions (upwards,
downwards or across).
- Make overlapping passes over the head
to ensure that the product catches all
hairs that need to be cut.
- Make sure that the flat part of the hair
clipping comb is fully in contact with the
scalp to obtain an even clipping result.
- If you wish to shape contours, tilt the
product.
- Regularly remove cut hair from the hair
clipping comb. If a lot of hair has
accumulated in the comb, remove it from
the product and blow and/or shake the
hair out of it.
Detaching and attaching click-on guards
1 To detach a guard from the cutting
element, push the hook at the back of
the comb upwards, then unhook it at the
front (Fig. 3).
2 To attach a guard onto the cutting
element, hook it onto the front of the
cutting element and push it down at the
back ('click') (Fig. 2).
Turning the product on and off
1 To turn on the product, push the on/off-
button upwards (Fig. 5).
2 To turn off the product, push the on/off-
button downwards (Fig. 5).
Clipping with click-on guard
1 Place the desired guard onto the product
(‘click’) (Fig. 2).
2 Turn on the product (Fig. 5).
3 Place the guard on the scalp and move
the product through the hair slowly.
Guard sizes
Barbershop
numbers
Guard
sizes in
mm
Guard sizes
in inches
1
3
1/8
2
6
1/4
3
9
3/8
4
12
1/2
5
16
5/8
