INSTALLATION INSTRUCTIONS
1. Make sure power is turned OFF before installing or servicing this fixture.
2. This fixture must be mounted to a junction box or mounting stake that is UL Listed for line voltage.
Mounting stakes S3, M0028A, or junction box TM2H, TMC2H, BI1, BI2, BI3, BI4 may be used.
3. Insert wires through 1/2-14 NPS hole of mounting device and screw fixture onto junction box lid/stake cap.
4. Wire the fixture as follows, using wire nuts to make the splices inside the junction box.
-Connect white (positive) supply wire to white fixture wire.
-Connect black (negative) supply wire to black fixture wire.
-Connect green (ground) supply wire to green fixture wire.
5. Secure the junction box lid/stake cap back onto the junction box/mounting stake.
6. Loosen shroud screws and remove shroud by pulling off of housing.
7. Install specified lamp (not included).
8. Push shroud completely back into housing and tighten shroud screws to secure shroud in place.
9. Loosen screw in arm, aim fixture as desired and tighten screw.
10. Turn power ON.
INSTRUCTIONS PERTAINING TO A RISK OF FIRE OR INJURY TO PERSONS
IMPORTANT SAFETY INSTRUCTIONS - SAVE THESE INSTRUCTIONS!
WARNING - Lamp gets HOT quickly! To reduce the risk of FIRE OR INJURY TO PERSONS:
Do not operate fixture with a missing or damaged lens/lens assembly.
Contact only switch or plug when turning fixture on or off. Do NOT touch hot lens or housing.
Turn off or unplug fixture and allow to cool before relamping. Keep lamp away from combustibles.
Do NOT touch lamp with bare hands at any time; use a soft cloth as oil from skin may damage lamp.
page 2 of 2
32001330, revision B