3
Put a coffee oil remover tablet in the pre-ground coffee compartment.
4
Press the CLASSIC COFFEE button. The machine dispenses water from
the coffee dispensing spout.
5
When the progress bar has reached the middle, set the main switch on
the back of the machine to OFF.
6
Let the coffee oil remover solution act for approximately 15 minutes.
7
Set the main switch to ON. Press the standby button.
8
Wait until the machine performs an automatic rinsing cycle.
9
Perform the 'Weekly cleaning of the brew group' procedure.
10
Remove the drip tray with the coffee grounds container and empty them.
Then place them back into the machine.
11
Press the AROMA STRENGTH button and select pre-ground coffee.
12
Press the CLASSIC COFFEE button. The machine dispenses water from
the coffee dispensing spout.
13
Repeat steps 11 and 12 twice. Discard the dispensed water.
Reinserting the brew group
1
Before you slide the brew group back into the machine, make sure the
two yellow reference signs on the side match. If they do not match,
perform the following step:
-
Make sure the lever is in contact with the base of the brew group.
2
Make sure that the yellow locking hook of the brew group is in the correct
position.
-
To position the hook correctly, push it upwards until it is in uppermost
position.
16
English
