Philips Desa DR16124, Installation Instructions Manual

Page: 22 / 88

22
5.2 Motion Setup
Motion detection allows the DÉSA recorder to record any activity within the video, without using external alarm inputs.
Ref Name Description
1 Camera (1–16) Click the corresponding camera number button to set up its’ motion
zone(s).
2 Detection area To create the detection area(s), place the mouse pointer over the
desired area, left click, and drag until the desired area is fully covered.
Up to 5 motion detection areas can be assigned to each camera.
3 Area clear Click Area clear to clear all of the detection area(s).To erase a
portion of a detection area, move the mouse pointer over the detection
area, then click and drag until the desired area is cleared.
4 Area draw Click Area draw to create a detection area over the entire video
image.
5 Sensitivity This slider bar controls the sensitivity of the detection area(s), so
different levels of sensitivity can be configured for the individual
cameras.
6 Alarm (M) Enables an audible tone (PC speaker beep) when motion is sensed.
7 Individual camera adjustment To improve the performance of the video motion detection, adjust the
video brightness, color, and contrast for each camera. Default value for
each camera is
0 .
8 Color/Monochrome If the camera is black and white, click Color to change the setting
to Monochrome .
Default setting is Color .
9 Default Click Default to return the settings back to factory default values.
10 Recording frame rate per camera The frame rate recorded per camera is adjustable by dragging the
horizontal slide bar. Clicking
Default results in the recording frame
rate per camera being reset to default values.
11 Setup for all cameras - Area clear Erases all of the selected motion areas for all cameras .
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
Continued on next page . . .