Preparation
1
Press the
y
Standby button
twice
to put the projector in Power/Standby.
–
The Standby indicator starts blinking red.
2
Wait until the cooling fan has stopped (about 3 minutes after the projector has been put in
Standby) and disconnect the mains lead and all other cables.
3
Put the lens cap back in place to prevent dust, dirt or other contamination from harming or
damaging the front of the projector lens when moving the projector.
Never place the projector on the side where the connections are located.
Moving/transporting the projector
The projector contains many glass and precision parts. If you need to transport the projector,
please follow these packing instructions to prevent accidental damage to the projector.
•
When you are hand-carrying the projector, be sure to use a carrying case like the optional
softbag.
•
When shipping the projector, use the original packaging material if possible. If you do not
have the original packaging, use equivalent materials, placing plenty of cushioning around the
projector.
•
When transporting the projector as freight or checked luggage, first put it in a carrying case,
then pack it in a firm box, using cushioning around the case.
1
Push and slide the lid in the direction of the arrow.
2
Install two ‘AA’ batteries as indicated inside the battery compartment.
3
Replace the lid and snap it into place.
The maximum range of the remote control is approximately 15 m (± 50 feet).
Moving/transporting the
projector
Note
Inserting the batteries in
the remote control
Note
Philips Multimedia Projector
13
English
User guide
bClever SV1
3. Set up
<