Philips Avent SCD570/00, User Manual

Page: 23 / 328

23
Why don’t I hear a sound/Why can’t I hear
my baby cry?
• The volume of the parent unit may be too low
or may be switched off. Increase the volume of
the parent unit.
• The microphone sensitivity level of the baby
unit may be too low. Set the microphone
sensitivity level to a higher level in the menu of
the parent unit.
• The baby unit and the parent unit may be out
of range of each other. Reduce the distance
between the units.
Why does the parent unit react too quickly to
other sounds?
• The baby unit also picks up other sounds than
those of your baby. Move the baby unit closer
to the baby (but observe the minimum distance
of 1 metre/3.5 feet).
• The microphone sensitivity level of the baby
unit may be too high. Decrease the microphone
sensitivity level in the menu of the parent unit.
Why does the parent unit react slowly to the
baby’s crying?
• The microphone sensitivity level of the baby
unit may be too low. Increase the microphone
sensitivity level of the baby unit in the menu of
the parent unit.
• The Eco Max mode is on and the baby unit
only switches on the DECT signal when the
baby makes sounds. Switch off the Eco Max
mode to make the baby unit transmit DECT
signals continuously and to make the parent unit
respond more quickly to your baby’s sounds.
Why do the non-rechargeable batteries of the
baby unit run low quickly?
• The microphone sensitivity level of the baby
unit may be too high, which causes the baby
unit to transmit more often. Decrease the
microphone sensitivity level in the menu of the
parent unit.
Why does the ‘link’ light on the parent unit lash
red continuously and why is the message ‘NOT
LINKED’ or ‘I AM LINKING’ shown on the display?
• The baby unit and the parent unit are out
of range of each other. Move the parent unit
closer to the baby unit.
• The baby unit may be switched off. Switch on
the baby unit.
Why does the battery status light on the baby
unit lash red?
• The non-rechargeable batteries of the baby unit
are running low. Replace the non-rechargeable
batteries or connect the baby unit to the mains
(see chapter ‘Preparing for use’).
Why does the parent unit beep?
• If the parent unit beeps while the ‘link’ light
lashes red continuously and the message ‘NOT
LINKED’ or ‘I AM LINKINg’ is shown on the
display, the connection with the baby unit is lost.
Move the parent unit closer to the baby unit or
switch the baby unit on, if it was off.
• If the parent unit beeps and the battery symbol
on the display is empty, the rechargeable
batteries of the parent unit are running low.
Recharge the batteries.
• If you have set the room temperature range on
the parent unit and the temperature alert is on,
the parent unit beeps when the temperature
drops below the set minimum temperature
range or when the temperature rises above the
set maximum temperature range.
• The baby unit may be switched off. Switch on
the baby unit.
Why does the appliance produce a high-pitched
noise?
• The units may be too close to each other. Make
sure the parent unit and the baby unit are at
least 1 metre/3.5 feet away from each other.
• The volume of the parent unit may be too high.
Decrease the volume of the parent unit.
ENgLISh