Philips Avent DECT baby monitor SCD520, Manual

Page: 17 / 26

Reset function
This function allows you to reset the parent unit and the baby unit to
the default settings. You can use this function if problems occur that you
cannot solve by following the suggestions in chapter ‘Frequently asked
questions’. You have to reset each unit separately.
1 Press the on/off button to switch off the parent unit. Remove the
small plug from the parent unit and the adapter from the wall socket.
Press and hold the volume down (-) button. Put the small appliance
plug in the parent unit and put the adapter in the wall socket.
Wait for the parent unit to complete its automatic restart at its
default settings before you release the volume down (-) button.
Proceed in the same way to reset the baby unit.
Default settings
Parent unit
Loudspeaker volume: 1
Microphone sensitivity: 3
Baby unit
Loudspeaker volume: medium
Nightlight: off
Accessories
Belt clip
If the battery pack of the parent unit is sufficiently charged, you can take
the unit with you inside and outside the house if you attach the unit to
your belt with the belt clip. This allows you to monitor your baby while you
are moving around.
Connecting the belt clip
1 Snap the belt clip onto the parent unit.
Disconnecting the belt clip
1 Pull the belt clip off the parent unit.
Cleaning and maintenance
Do not immerse the parent unit or the baby unit in water and do not
clean them under the tap.
Do not use cleaning spray or liquid cleaners.
1 Unplug the baby unit or the parent unit if they are connected to an
electrical outlet.
Clean the parent unit and the baby unit with a damp cloth.
Make sure the units are dry before you connect them to an electrical
outlet.
-
-
-
-
EngliSh
1