Philips Avent DECT baby monitor SCD520, Manual

Page: 16 / 26

nightlight
1 Press the nightlight button
Q
on the baby unit to switch on the
nightlight.
Press the nightlight button
Q
again to switch off the nightlight.
The nightlight dims gradually before it goes out completely.
Tip: Switch off the nightlight when you operate the baby unit on the non-
rechargeable batteries. This saves power.
Paging the parent unit
If you have misplaced the parent unit and its volume is switched off, you
can use the PAGE button on the baby unit to locate the parent unit.
Note: The paging function only works when the parent unit is switched on.
1 Press the PAGE button on the baby unit.
The parent unit produces a paging alert tone.
To stop the paging alert tone, press the PAGE button again or press
any button on the parent unit.
Out of range alert
When the parent unit is out of range of the baby unit, the parent unit
beeps from time to time. The LINK light on the parent unit flashes red.
Note: The LINK light on the parent unit also flashes red when the baby unit is
switched off.
Microphone sensitivity
You can set the microphone sensitivity of the baby unit to the desired level
with the SENSITIVITY button on the parent unit. You can only change the
microphone sensitivity when a connection between the baby unit and the
parent unit has been established, i.e. when the LINK light on the parent unit
lights up green continuously.
1 Briefly press the SENSITIVITY button on the parent unit.
The sound level lights light up for approx. seconds to indicate the
current sensitivity level.
Briefly press the and - buttons on the parent unit until
the desired microphone sensitivity level for the baby unit has been
reached.
one light on = minimum sensitivity level
all lights on = maximum sensitivity level
Note: When the microphone sensitivity of the baby unit is set to a high level, it
picks up more sounds and therefore transmits more often. As a result, the units
consume more power.
,
,
,
,
,
EngliSh
16