Philips AIRFLOSS PRO, Directions For Use Manual

Page: 11 / 88

Using the appliance
1 Make sure the AirFloss Pro is switched on. If it is off, press and
release the power/mode button to switch on the appliance. (Fig. 8)
,
You can change the modes to have the desired amounts of bursts
each time you press the activation button. For optimal results, use
the triple burst mode (the default setting) from both the outside
and inside of your teeth.
,
To change modes, press the power/mode button to cycle through
the modes until you reach your desired mode. The LEDs show the
selected mode:
- Single burst: 1 LED (Fig. 10)
- Double burst: 2 LEDs (Fig. 11)
- Triple burst: 3 LEDs (Fig. 12)
Note: The AirFloss Pro remembers what mode was selected last and it is
ready for the next use. If your AirFloss Pro becomes fully drained of power,
it will go back to the triple burst default mode once it has been recharged.
2 Place the nozzle tip between two teeth at your gum line.
Slightly close your lips over the nozzle when it is in place,
to avoid splashing (Fig. 13).
3 Press the activation button to deliver 1-3 bursts (depending on
the selected mode) of air and micro-droplets of mouthwash or
water between the teeth. (Fig. 14)
4 Slide the nozzle tip along the gum line until you feel it settle
between the next two teeth.
5 Continue this procedure for all spaces between your teeth,
including behind your back teeth (Fig. 15).
Note: Refill the reservoir as needed.
ENGLISH
11