7.5 Connecting a PC Using RGB
or DVI Video Input
1. For most PC’s, connect the 15-pin D-Sub
RGB
connector from the back of the PC to
the
RGB-IN
connector located on the back
of the display. If you have a PC that is
equipped with a DVI (Digital Visual Interface),
you may connect the PC DVI connector
from the back of the PC to the DVI-In
connector located on the back of the display.
2. Connect the red (R) and white (L) audio
jacks from the PC to the R and L jacks
located to the left of the
S-VIDEO
connector. If you are using a DVI interface,
simply connect the (R) and (L) audio jacks to
the R and L jacks located to the left of the
VIDEO 1
connector.
Notes:
•
Your PC may have audio jacks in the form of
a 3.5mm phono plug. If this is the case, you
will need to use a phono-plug to RCA
converter cable in order to connect audio.
•
A RGB loop-out labeled iaRGB OutlB will
allow another RGB display to be connected.
The RGB loop-out will display the same
signal as the RGB In signal source.
•
The physical display resolution is a maximum
of 1024x768 dots when aspect ratio is set to
4:3
and 1366x768 dots when set to
16:9.
If the PC’s display resolution exceeds these
maximums, the display will have to artificially
eliminate dots in order to fit within the
physical dot capability of the display.
Therefore, it is possible that the display may
not be able to show details with adequate
clarity.
18
User Manual BDH5011
Summary of Contents for 50-WXGA PLASMA MONITOR BDH5011
Page 59: ...59 User Manual BDH5011 ...
