Philips 247E3LHSU/00, Service Manual

Page: 113 / 119

Meridian 3 113
Step
Between bezel and rear cover: -0.2 mm
”
STEP
”
0.5 mm
Location of Control icons -
Per Philips Graphic sheet
Color for resin/paint -
Per Philips make-up sheet
Fire enclosure request
Shielding Cover should fulfill international standard
Resins
x
RoHS required
x
WEEE required.
x
Resin type/selection refer to Project Book Section 7.2 Plastic material.
If paint is used
x
RoHS required
x
WEEE require
x
If new painting type need to implement, refer to UN-D 1235.
Plastic mold tooling
x
Tooling to be designed to minimize cosmetic defects induced by molding process (sink, blush, weld
lines, gate marks, ejector marks, etc.). Refer to “TYV61-90007”.
x
Painting to cover up cosmetic defects due to molding is strongly discouraged.
x
China RoHS mark requested.
Plastics flammability
x
All Plastics to be Flame Retardant UL 94-HB or Better.
x
Base / Pedestal to be Flame Retardant UL 94-HB.
x
All major plastic parts (bezel, back cover) need to be molded from same resin.
x
Plastic resin type selection should be referred to “plastic-Philips Pool monitor”.
Texture/Glossing of housing
x
The texture area and texture no should follow Philips make-up sheet.
x
The exterior surfaces shall have a uniform texture.
x
Philips must approve the mold texturing.
x
Detail document for texture refer to “UN-D249”, “UN-D 600”.
x
< = 20 gloss units
Headphone jack
Connector
SEC A-A
1.0±0.7mm(round)