Philips 200PW8ES/00, Service Manual

Page: 10 / 84

10
HUDSON 8
Warning Message
Ite
m
Attention Signals Display Time Condition
1 CANNOT DISPLAY THIS
VIDEO MODE, CHANGE
COMPUTER DISPLAY
INPUT TO 1680X1050 @
60HZ
30 mins This warning appears when the input signal from your computer is not in
a standard video mode or is out of the monitor s scanning range. After
30 mins, monitor enters sleeping mode.
2 NO VIDEO INPUT 30 mins This message appears when there is no signal input but with cable while
AC or DC power on. After 30 mins, monitor enters sleeping mode.
3 CHECK CABLE
CONNECTION
30 mins This message appears when a signal cable is disconnected while
monitor is working. After 30 mins, monitor enters sleeping mode.
4 ENTERING SLEEP MODE 3 secs This message appears when monitor is about to enter power saving
mode.
5 WAITING FOR AUTOMATIC
ADJUSTMENT
till auto adjustment
finished
This message is displayed when the auto adjustment button is pressed.
It disappears when automatic adjustments are completed.
6 USE 1680X 1050 FOR BEST
RESULT
On top of OSD main
menu
The message will show up at the top of the OSD main menu in red color
when the input resolution is not the 1680x1050.
7 OSD MAIN CONTROLS
LOCKED
3 secs / or Till "OSD
MAIN CONTROLS
UNLOCKED"
appear
This message will appear 3 seconds to indicate the OSD MAIN
CONTROLS status when to lock or un-lock it by pressing "MENU(OK) "
button for more than 10 seconds while there is video input from PC. This
function provides the alternative that user can lock all the OSD main
control in case user don t want the FOS performance setting to be
changed, for instance, during commercial exhibition.
8 OSD MAIN CONTROLS
UNLOCKED
3 secs This message will appear 3 seconds to indicate the OSD MAIN
CONTROLS status when to un-lock it by pressing "MENU (OK) " button
for more than 10 seconds while there is video input from PC.
9 the window of "VOLUME" 60 secs This message will appear when the VOLUME button is pressed.
10 THIS IS 85HZ OVERSCAN,
CHANGE COMPUTER
DISPLAY INPUT TO
1680X1050@60HZ
10 mins This message will appear 5 seconds in every 60 seconds for 10 minutes
when the input of PC video timing is at 85Hz mode.
Remark: AUTO is still functional in this mode
11 the window of OSD
"MONITOR SETUP "
60 secs This message will appear when the "OK" button is pressed.
12 the window of
"BRIGHTNESS"
60 secs This message will appear when the BRIGHTNESS button is pressed.
13 "SELECTED INPUT NOT
AVAILABLE"
3 secs This message will appear 3 seconds to indicate the SIGNAL SOURCE
status when change the signal source but it is not found while there is
video input from PC.
Warning message table
http://www.wjel.net