Horizontal flicker appears
Eliminate the horizontal bars using the Phase
Adjustment of VIDEO NOISE in OSD Main
Controls.
●
The screen is too bright or too dark
Adjust the contrast and brightness in OSD
Main Controls. (The backlight of the product
has a fixed life span. When the screen
becomes dark or begins to flicker,
please
contact your dealer.
●
An after-image appears
If an image remains on the screen for an
extended period of time, it may be imprinted in
the screen and leave an afterimage This
usually disappears after a few hours
●
An afterimage remains after the power
has been turned off.
This is characteristic of liquid crystal and is not
caused by a malfunction or deterioration of the
liquid crystal. The afterimage will disappear
after a given amount of time
●
Green, red, blue, dark and white dots
remain.
The remaining dots are normal characteristic
of the liquid crystal used in today’s
technology.
●
Visible brighter spots in dark scenes
The brighter spots are normal when the
ambient light is very low.
●
Increase the ambient light to make the spots
invisible
●
TV and Audio Problems
Poor TV signal reception
The proximity of mountains or high buildings
may be responsible for ghost pictures,
echoing or shadows. In this case, try manually
adjusting your pictures: see 'fine tuning' or
adjust the direction of the outside aerial.
For Asia users in non-NTSC area: Does your
antenna enable you to receive broadcasts in
this frequency range (UHF or VHF band)? In
the event of difficult reception (snowy pictures)
switch the NR on the PICTURE menu to ON.
●
Troubleshooting
file:///D|/TV/english/150mt2/safety/saf_troub.htm (2 of 3) [12/24/2002 11:46:14 AM]
