*Dimmer
This device is able to set dimmer level by rotating to different angle.
When the status is Off, surround LED will not work except in area
A(shown in Fig. 1). Rotate the device to area B, C, D(shown in Fig.
1) then touch the button can set the status to On. After a short
beep, the surround LED will change gradually from blue to red and
send different level to group 2 in area B when rotating. To turn Off
the device in group 2, you can rotate PSR07 to area C or touch the
button again.
*Binary Switch
This device is able to work as an On/Off state switch by pressing the
touch button when fitting horizontal.
Association
This device supports 2 association groups which every group has
eight node support.
To build/disable association between devices,
1. Have the Z-Wave controller entered association mode.
2. Rotate PSR07 to area A then touch the button.
Group 1 is for receiving the report message, like the battery level.
Group 2 is for light control, the device will send Basic Set command
to this group.
Timing Report
The device supports the timing unsolicited report of the status.
• Battery level report: Every 6 hours report once in default.
It could be changed by setting the configuration NO. 10.
• Low battery report: When the battery level is too low, every 30
minutes will report once.
Z-Wave
TM
Notification
After the device adding to the network, it will wake-up once per day
in default. When it wake-up it will broadcast the “Wake Up
Notification” message to the network, and wake-up 10 seconds for
receive the setting commands. The wake-up interval minimum
setting is 30 minutes, and maximum setting is 120 hours. And the
interval step is 30 minutes. If the user want to wake-up the device
immediately, please rotate to area A and pressing the touch button
once. The device will wake-up for 10 seconds every single time.
Figure
1