Troubleshooting
Symptom
Cause of Failure
Recommendation
The device can not
join to Z-Wave™
network
The device may in a Z-
Wave™ network.
Exclude the device
then include again.
Installation Steps
1.
Connect 5-24V&GND to 5-24VDC.
2.
Connect K/J/T Type Thermocouple to CH1/CH2.
***When installing a thermocouple, please pay attention to the
positive and negative polarity of the thermocouple. If the
installation is wrong, the temperature measurement will be
wrong.
For Instruction to http:// www.philio-tech.com
Add to/Remove from Z-Wave
TM
Network
There is a button with LED indicator in front of PAT14. It is used to
dim on/off the light and carry out the inclusion, exclusion, reset or
association of PAT14 from Z-wave controller.
When the fist power one, the LED indicator flashes once per second
for 30 seconds. With the SmartStart function, PAT14 will be
automatically included by Z-wave controller.
PAT14 can be operated with any certified Z-Wave™ devices from
different manufacturers in Z-Wave™ network. All non-battery operating
devices act as repeaters to increase the stability and reliability of the Z-
Wave™ network.
2
