3
Adding to Z-Wave
TM
Network
In the front casing, there is an on/off button with LED indicator below which is used
to toggle switch on and off. The table below lists an operation summary of basic
Z-Wave functions. Please refer to the instructions for your Z-Wave
TM
Certificated
Primary Controller to access the Setup function, and to include/exclude/reset
devices
Function
Description
LED Indication
No node ID
The Z-Wave Controller does not allocate
a node ID to the Switch.
2-second on, 2-second off
Add
(Inclusion)
Have Z-Wave Controller entered
inclusion mode.
One press one flash
※
To support handling of the
device when already installed
the external switch can be
used for inclusion or exclusion
for 3 minutes after power up.
Pressing Include button of PAN33 three
times within 2 seconds will enter
inclusion mode.
SmartStart
1. To initiate the SmartSart process,
please type in the first five digits of
DSK string or scan the QR code. The
QR Code can be found on PAN33 or
in the box. Ex:
DSK: 18112-24021-58001-62259-
57092- 27453-08187-47408
2. PAN33 is supported with SmartStart, it
can be added to Z-Wave™ network by
scanning the Z-Wave™ QR code on
the product.
3. Without further actions, PAN33 will be
automatically included in a certified
Z-Wave™ Controller with SmartStart
inclusion ability in 10 minutes after it
turned on.
Remove
(Exclusion)
Have Z-Wave Controller entered
exclusion mode.
One press one flash
※
To support handling of the
device when already installed
the external switch can be
used for inclusion or exclusion
for 3 minutes after power up.
Pressing Include button of PAN33 three
times within 2 seconds will enter
exclusion mode.
Node ID has been excluded.
2s On, 2s Off (No node ID)
Reset
Pressing Include button of PAN33 three
times within 2 seconds will enter
inclusion mode.
One press one flash
Within 1 second, press Include button of
PAN33 again for 5 seconds.
IDs are excluded.
2s On, 2s Off (No node ID)
※
Adding
a node ID allocated by Z-Wave Controller means inclusion.
Removing
a node
ID allocated by Z-Wave Controller means exclusion.
※
Failed or success in including/excluding the node ID can be viewed from the Z-Wave
Controller.
※
Sometimes people are not easy to execute exclusion or inclusion especially when PAN33
already installed in a wall box. To solve this issue, PAN33 support a special feature that can
use S1 or S2 to execute “exclusion, inclusion, Reset or Association” at the first 3 minutes when
first time connect to main power.
LED Indication
There is a LED for identify function in the front case.
PAN33
support the indicator
ID 0x50 (Identify) and Properties ID 0x03, 0x04 and 0x05.
To distinguish what mode the switch is in, view from the LED for identification.
State Type
LED Indication
Normal
When PAN33 switch On the LED will lights up, when PAN33 switch
Off the LED will lights off.
No node ID
Under normal operation, when the Switch has not been allocated a
node ID, the LED flashes on and off alternately at 2-second intervals.
Overload
When overload state occurs, the Switch is disabled of which LED
flashes on and off alternately at 0.2 second intervals. Overload
state can be cleared by disconnect and reconnect the Switch to
the main power.
Installation
