2
illuminating, but cannot
control the ON/OFF
Switch of the
attached load
into the Switch has its own
ON/OFF switch
attached load
to ON
The Switch LED
illuminating, but the
detector cannot control
the Switch
1. Not carry out association
2. Same frequency
interference
1. Carry out association
2. Wait for a while to re-try
LED keep flashing
continuously, but cannot
control
Overload occurs
Remove the
attached load
or
check max. load cannot exceed
85°C (230Vac/120Vac)
(Resistive load)
Installation Steps
1. Connect PAN33 to AC N and L.
2. Connect
Load
to NO1.
3. Connect external Switch S1 and S2 to L.
Fig 1. Assembling
and wiring
For Instruction to http:// www.philio-tech.com
DANGER
Danger of electrocution!
All works on the device may be performed only by a qualified and licensed
electrician. Observe national regulations.
Any works introducing changes into the configuration must be always
performed with disconnected voltage.
Choosing a Suitable Location
1. Do not locate the Module facing direct sunlight, humid or dusty place.
2. The suitable ambient temperature for the Module is 0°C~40°C.
3. Do not locate the Module where exists combustible substances or any source
of heat, e.g. fires, radiators, boiler etc.
4. After putting it into use, the body of Module will become a little bit hot of which
phenomenon is normal.
