electrical outlet
properly
2. The Switch break
down
send it for repair.
The Switch LED
illuminating, but cannot
control the ON/OFF
Switch of the load attached
1.Check if the load
plugged into the Switch
has its own ON/OFF
switch
2. The switch is protected
1. Set the ON/OFF switch of the
load attached to ON
2. Unprotected the switch or follow
the instruction of protection.
The Switch LED
illuminating, but the
Detector cannot control
the Switch
1. Not carry out
association
2. Same frequency
interference
1. Carry out association
2. Wait for a while to re-try
LED keep flashing, but
cannot control
Overload occurs
Remove the load attached or check
max. load cannot exceed
12.0A(Resistive load)
Specification
Operating Voltage
100 ~240VAC /50Hz/60Hz
Maximum Load
11A (Resistive load)
Range
Minimum 40 m in door 100m outdoor line of sight
Operating Temperature 0°C ~ 40°C
Frequency Range
PAN03-1: 868.40MHz; 869.85MHz(EU) /
PAN03-2: 908.40MHz; 916.00MHz(USA/Canada) /
PAN03-3: 922.5MHz/ 923.9MHz/ 926.3MHz (Taiwan/JP)
PAN03-IL: 916.00MHz(Israel)
PAN10-1: 868.40MHz; 869.85MHz(EU) /
PAN10-2: 908.40MHz; 916.00MHz(USA/Canada) /
PAN10-3: 922.5MHz/ 923.9MHz/ 926.3MHz (Taiwan/JP)
PAN10-IL: 916.00MHz(Israel)
** Specifications are subject to change and improvement without notice.
FCC ID : RHHPAN03
DANGER
Danger of electrocution!
All works on the device may be performed only by a qualified and licensed
electrician. Observe national regulations.
Any works introducing changes into the configuration must be always performed with
disconnected voltage.
Choosing a Suitable Location
1. Do not locate the Module facing direct sunlight, humid or dusty place.
2. The suitable ambient temperature for the Module is 0°C~40°C.
3. Do not locate the Module where exists combustible substances or any source of
heat, e.g. fires, radiators, boiler etc.
4. After putting it into use, the body of Module will become a little bit hot of which
phenomenon is normal.
11
