Whenever PAN03 is manually switch on or off, it will send BINARY_SWITCH_
REPORT to the node of group1. The default setting is Enable the function.
3-12 Watt differential report mode :
3-12-1 Disable : The function of Watt differential report will be disabled.
3-12-2 5% : When the differential value of Watt is over 5%, PAN03/PAN10 will send
a meter report to the associated group.
3-12-3 10% : When the differential value of Watt is over 10%, PAN03/PAN10 will
send a meter report to the associated group.
3-12-4 15% : When the differential value of Watt is over 15%, PAN03/PAN10 will
send a meter report to the associated group.
3-12-5 20% : When the differential value of Watt is over 20%, PAN03/PAN10 will
send a meter report to the associated group.
4. Protection Command Classes
PAN03/PAN10 supports Protection Command Class version 2, it can protect the
switch against unintentionally control by e.g. a child. And it can also protect the
switch from being turned off by setting it in “No RF Control” state.
After being set to “Protection by sequence” state, any intentional pressing of On/Off
button should be hold longer than 1 second, or the switch state will not change.
However, the operation of learn function does not change, because learning will not
be protected.
5. Firmware update over the air (OTA)
PAN03 is based on 500 series SoC and supports Firmware Update Command Class,
it can receives the updated firmware image sent by controller via the Z-wave RF me-
dia. It is a helpful and convenient way to improve some function if needed.
6. Command Classes
The Switch supports Command Classes including…
* COMMAND_CLASS_ZWAVEPLUS_INFO
* COMMAND_CLASS_VERSION
* COMMAND_CLASS_MANUFACTURER_SPECIFIC_V2
* COMMAND_CLASS_SECURITY
* COMMAND_CLASS_DEVICE_RESET_LOCALLY
* COMMAND_CLASS_ASSOCIATION_V2
* COMMAND_CLASS_ASSOCIATION_GRP_INFO
* COMMAND_CLASS_POWERLEVEL
* COMMAND_CLASS_SWITCH_BINARY
* COMMAND_CLASS_BASIC
* COMMAND_CLASS_SWITCH_ALL
* COMMAND_CLASS_METER_V3
* COMMAND_CLASS_CONFIGURATION
* COMMAND_CLASS_ALARM
* COMMAND_CLASS_PROTECTION
* COMMAND_CLASS_FIRMWARE_UPDATE_MD_V2
Troubleshooting
Symptom
Cause of Failure
Recommendation
The Switch not working and
LED off
1. The Switch is not
plugged into the
1. Check power connections
2. Don’t open up the Switch and
10
