Slim Multi-sensor PST07
The multi sensor is a Z-WaveTM enabled device which is fully
compatible with any Z-WaveTM enabled network. This device is a
security enabled Z-Wave Plus product that is able to use encrypted Z-
Wave Plus messages to communicate to other security enabled Z-
Wave Plus products. Z-WaveTM enabled devices displaying the Z-
WaveTM logo can also be used with it regardless of the manufacturer,
and ours can also be used in other manufacturer’s Z-WaveTM enabled
networks.
The product supports Over The Air(OTA) feature for the products
firmware upgrade.
This product can be included and operated in any Z-Wave
TM
network
with other Z-Wave
TM
certified devices from other manufacturers and/or
other applications. All non-battery operated nodes within the network
will act as repeaters regardless of vendor to increase reliability of the
network.
The device adopt the Z-Wave
TM
500 series chip, when your Z-Wave
TM
network system is all made by Z-Wave
TM
500 series devices. The
network system will have the advantages as below.
•
Concurrent multi-channel support reduces external interference.
Add to/Remove from Z-Wave
TM
Network
There are two tamper keys in the device, one is in the back side,
another is in the front side. Both of them can add, remove, reset or
association from Z-Wave
TM
network.
The table below lists an operation summary of basic Z-Wave functions.
Please refer
to the instructions for your Z-WaveTM Certificated Primary Controller to
access the
Setup function, and to Add/Remove/associate devices
Notice
: Including a node ID allocated by Z-Wave
TM
Controller means
“
Add
” or “
Inclusion
”. Excluding a node ID allocated by Z-Wave
TM
Controller means “
Remove
” or “
Exclusion
”.
Function
Description
Add
1.
Have Z-Wave
TM
Controller entered inclusion mode.
2. Pressing tamper key three times within 2 seconds
to enter the inclusion mode.
3.
After add successful, the device will wake to
receive the setting command from Z-Wave
TM
Controller about 20 seconds.
Remove
1.
Have Z-Wave
TM
Controller entered exclusion mode.
2. Pressing tamper key three times within 2 seconds
to enter the exclusion mode.
Node ID has been excluded.
1
