8
Troubleshooting
Symptom
Cause of Failure
Recommendation
The Switch not working and
LED off
1.
The Switch is not
plugged into the
electrical outlet
properly
2.
The Switch break down
1.
Check power connections
2. Don’t open up the Switch and send it for
repair.
The Switch LED
illuminating, but cannot
control the ON/OFF
Switch of the load attached
1.Check if the load
plugged into the Switch
has its own ON/OFF
switch
2. The switch is protected
1. Set the ON/OFF switch of the load
attached to ON
2. Unprotected the switch or follow the
instruction of protection.
The Switch LED
illuminating, but the
Detector cannot control
the Switch
1. Not carry out
association
2. Same frequency
interference
1. Carry out association
2. Wait for a while to re-try
LED keep flashing, but
cannot control
Overload occurs
Remove the load attached or check max.
load cannot exceed 13A (Resistive load)
Specification
Operating Voltage
220V~240V / 50Hz for EU Type
Operating Voltage
100V~120V / 50Hz/60Hz for US Type
Maximum Load (Ampere)
13A (Resistive load)
PAN16-1; PAN16-2; PAN16-3
Maximum Load (Ampere)
10A (Resistive load)
PAN16-4
(Switzerland)
Socket Type:
Germany type: PAN16-1
France type: PAN16-2
UK type: PAN16-3
Switzerland type: PAN16-4
Range
Minimum 40 m in door 100m outdoor line of sight
Operating Temperature
0°C ~ 40°C
Frequency Range
868.40MHz & 869.85MHz/ EU (PAN16-1/-2/-3/-4);
RF Maximum Power
+5dBm
** Specifications are subject to change and improvement without notice.
Warning:
1.Plug out to disconnect from power supply; Do not plug in line.
2. Do not exceed the max rating.
Warnung:
1.Trennen Sie das Gerät von der Stromzuführung. Verwenden Sie das Gerät
nicht mit einem DIP Schalter.
2. Achten Sie darauf, dass die maximale Spannung niemals überschritten wird.
Warnung:
für zwischenstecker:
nicht hintereinander stecken
