Philco PLS 1061, User Manual

Page: 24 / 96

EN - 22
02/2011 Copyright © 2011, Fast ČR, a. s.
MALFUNCTION POSSIBLE CAUSE REMEDY
The results of the wash are not
satisfactory.
You have placed too much laundry
in the washing machine.
Only place as much laundry into
the washing machine as not to
exceed the maximum capacity of
the washing machine.
Maybe you have hard water.
Use as much washing detergent
so as to meet the instructions
of the washing detergent's
manufacturer.
The laundry is not evenly arranged
inside the washing machine.
Arrange the laundry inside the
washing machine so that it is
evenly arranged in the drum.
The water is drained out of the
washing machine immediately
after it has been fi lled. The end of the drain hose is
too low relative to the washing
machine.
Locate the drain hose at an
appropriate height. (**)
No water can be seen in the
drum during the wash.
This is not a malfunction. The
water is in the lower part of the
drum.
-
There are washing detergent
residues on the laundry.
Insoluble residues of the washing
detergent in the form of white
stains may appear on the laundry.
Set the calibration of your rinsing
program on your washing
machine to an additional rinse or
after the laundry has dried remove
the stains using a brush.
There are grey stains on the
laundry. These stains may be caused by oil,
a cream or a lotion.
During the next wash use the
maximum amount of washing
detergent set by its manufacturer.
Spinning does not take place
or it is very late.
This is not a malfunction. In this
way the test of the unbalanced
load may working.
The uneven contents testing
system may be trying to use a
homogeneous method to evenly
arrange the laundry in the drum.
After it is arrange the washing
machine will go to
the spinning process. For the next
wash, place the laundry arranged
evenly into the drum.
(**) See chapter referring to the installation of your washing machine.