EN - 19
03/2015
Copyright © 2015, Fast ČR, a. s.
PART 5: CONTROL FEATURES
Turning on the appliance
1. Load dishes into the upper and lower basket (see the next chapter). Check the salt and rinse aid indicators.
Load the dishwashing detergent.
2. Insert the plug into the socket (220 – 240 V ~ 50 Hz). Open the water inlet valve.
3. Close the door and press the Power button.
4. Select the washing program by the Program button.
5. Then press Start / Pause button.
Note:
You should hear a click sound when closing the door.
When the washing is fi nished, press the Power button and open the door.
Program change
A cycle that is underway can only be modifi ed if it has only been running for a short time. Otherwise, the
detergent may have already been released, and the appliance may have already drained the wash water. If this
is the case, the detergent dispenser must be refi lled.
1. Press Power button to cancel the program.
2. Select a new program by the Program button.
3. Press Power button again.
Note:
If you open the door when washing, the machine pauses and warning alarm rings, the display appears E1.
When you close the door, the machine will keep on working.
The 6 program lights show the state of the dishwasher:
a) One of the program lights on--> cycle running
b) One of the program lights blinking -->pause
Note:
If all the lights begin to glimmer, that indicates the machine is out of order, please turn off the main power
and water supply before calling a service.
Adding dish
A forgotten dish can be added any time before the detergent cup opens.
1. Open the door a little to stop the washing.
2. After the spray arms stop working, you can open the door completely.
3. Add forgotten dishes.
4. Close the door, the dishwasher will work after ten seconds.
WARNING
Open the dishwasher door only at exceptional cases and always open the door slightly and wait until the
spray arms end. Pay higher attention, water in the dishwasher could be very hot and it could cause burns.
