FSC-01
Motion Controller
POWER
PC/MMI
G
L2/N
L1
AC POWER
STOP
STEP+
STEP–
DIR+
DIR–
GND
+5 VDC
24V GND
+24 VDC
OUT3+
OUT3–
IN/JOG COM
IN1
OUT2–
OUT2+
OUT1–
OUT1+
CCWJOG/IN6
LIMIT COM
CW LIMIT
CCW LIMIT
CWJOG/IN5
IN4
IN3
IN2
I/O connector
+24V out, 100mA
+5V out, 100mA
step & dir out to driver
I/O connector
output 1,2,3
input 1
I/O connector
input 2,3,4
cw jog
ccw jog
cw limit
ccw limit
STOP button
mounting
bracket
LED
green = power on/status ok
flashing red = error
AC power
connector
RS232 connector
PC or MMI
Mechanical Outline: FSC-01
1.25
7.17
0.20
.625
7.625
8.00
3.86
0.06
FSC-01
Motion Controller
POWER
PC/MMI
G
L2/N
L1
AC POWER
STOP
STEP+
STEP–
DIR+
DIR–
GND
+5 VDC
24V GND
+24 VDC
OUT3+
OUT3–
IN/JOG COM
IN1
OUT2–
OUT2+
OUT1–
OUT1+
CCWJOG/IN6
LIMIT COM
CW LIMIT
CCW LIMIT
CWJOG/IN5
IN4
IN3
IN2
-4-
-17-
Getting Started
To use your FSC-01 motor control, you will need the following:
✔
a power cable (line cord)
✔
a compatible pulse & direction servo drive (PHD part number FSA-01)
✔
a small flat blade screwdriver for tightening the connectors - a screwdriver suitable for this
purpose is included with your drive.
✔
a personal computer running Windows 3.1, 95, 98 or NT with a 9 pin serial
port (486 or better with 8 MB ram recommended)
✔
the PHD Programmer software that came with your FSC-01
✔
the programming cable that came with your FSC-01
✔
PHD Programmer Manual (part #6441-333)
✔
PHD Quickstart Manual (part #6441-334)
The sketch below shows where to find the important connection and adjustment points. Please
examine it now.
All mating connectors are included.