Introduction
The Pro Series 2200 A/C-D/C backup sump pump
system is battery-operated. It is designed as an
emergency backup system to support your
regular AC sump pump, and it will automatically
begin pumping if your main AC pump fails.
Should any malfunction or emergency occur that
involves the sump pump, the battery, or the AC
power, your Pro Series system will sound an
alarm. A light on the display panel of the
control unit will indicate the cause of the alarm
and the corrective action.
If the main AC pump breaks or is unable to keep
up with all the incoming water, the Pro Series
pump is capable of running without discharging
the battery as long as the AC power is on.
The Pro Series Sump Pump System includes:
A control unit with a float switch and a
battery fluid level sensor
A pump with 1
1
⁄
2
” PVC pipe adapter
A plastic wire tie for mounting the float
switch
A battery box
A battery cap with a hole to accommodate
the fluid sensor
A battery filler bottle
You will also need to supply:
A Pro Series 2200 Standby
Battery, or another deep cycle
battery
1
1
⁄
2
” rigid PVC pipe and fittings
PVC cement and primer
A union or a “Y” connector and
two (2) check valves depending
on the installation method you
use
Six (6) quarts of 1.265 specific
gravity battery acid
Replacement Parts
Description
Part No
.
Pump
1011008
Float switch assembly
1020003
Fluid sensor assembly
1014001
Pipe adapter
1120002
Battery box
1113003
Battery cap with hole
1125000
Battery filler bottle
BFB-P
Call 800-991-0466, option 3 to
order parts.
System Specifications
Power supply requirements . . . . . . 115 volts AC
Pumping capacity . . . . . . . . . . 3500 GPH @ 0’
Pumping capacity . . . . . . . . . 2200 GPH @ 10’
Pump dimensions . . . . . . . . . . 7
5
⁄
8
H x 5
13
⁄
16
” W
Pump dimensions w/elbow . . . . . . 7
5
⁄
8
H x 9” W
Pump housing & strainer . . . . . .Non-corrosive,
will not rust
Pump . . . . . . . . . . . . . . . . . . . .Can run dry;
can be used in sumps with
water softener or laundry discharge
Float switch . . . . . . . . . . Independent; can be
set at any level
Page 2
Control Unit
Battery Box
Cap
Wire Tie
Float
Switch
Pipe Adapter
Pump
Battery Wires
Fluid Sensor
For narrow sump pits you will need some
additional parts:
An “L” bracket at least 6 inches long. (Preferably one that
will not rust.)
Two (2) stainless
steel hose clamps
One (1) stainless
steel screw (#8-32 x
3/4”), a matching
washer & nut
Battery
Filler
Bottle
