41
OPTIONAL COMPONENT
5.
Remove the caps (both outside and inside) covering the
access port for refrigerator and freezer and take out the
thermal insulation in the port. Pass the recorder sensor to
the chamber through each port [Fig. 5]. Then replace the
thermal insulation and caps (both outside and inside).
Also, replace the cap on the port for taking out the recorder
sensor.
The identification label is adhered to the lead wire to
distinguish between the sensor for refrigerator and for
freezer.
Make a cut on the caps for port to pass the lead wire as
shown in the Fig. 6.
6.
Fix the recorder sensor for refrigerator to the attachment
hole on the back side of the refrigerator by using the clips
enclosed with the recorder fixture (MPR-S7) [Fig. 7].
7.
Fix the recorder sensor for freeze to the attachment hole
on the left side of the freezer by using the clips enclosed
with the recorder fixture (MPR-S7) [Fig. 8].
8.
Operate the unit until the chamber (refrigerator and freezer) temperature gets to the set temperature.
Check the recorded temperature and chamber (refrigerator and freezer) temperature displayed on the
control panel. Adjust the zero adjustment volume on the temperature recorder so that the recorded
temperature can corresponds with the displayed temperature if they are not compliance each other.
Fig. 5
Lead wire
Clip
Recorder sensor
Clip
Recorder
sensor
Access
port
Fig. 6
Fig. 7
Fig. 8
