6/11
©
PHANTOS
®
Distributed in Australia by PHANTOS www.phantos.com.au
DMX Protocol:
6CH
DMX
Function
Ch1
0-255
Master dimmer
Ch2
0-255
Master strobe
Ch3
0-49
No function
50-99
Macro 1
100-149
Macro 2
150-199
Macro 3
200-255
Sound activated
Ch4
0-255
Macro speed
Ch5
0-255
White dimmer
CH6
0-255
Amber dimmer
3.4 Master/Slave Mode
In this mode, multiple units can be linked together as one system and run in sync.
Maximum
31pcs
can be linked in a daisy chain as Master/Slave system.
1. Use DMX cable to link your lights together via DMX OUT to DMX IN connector.
2. One of the fixtures is set as Master (refer to 3.1 Menu Map on how to set a
fixture as Master) and this unit can then be set to work under any of the Auto,
Macro, Static Color, or Sound mode specified in 3.1 Menu Map. Others are to be
set as Slave mode (refer to 3.1 Menu Map on how to set a fixture to Slave mode,
if not mentioned then set to DMX address
d001
).
3. All slave units will follow master unit.
7/11
©
PHANTOS
®
Distributed in Australia by PHANTOS www.phantos.com.au
4.SERVICING
4.1 Fuse Replacement
1. Disconnect this product from power.
2. Using a flat-head screwdriver, unscrew the fuse holder cap from the housing.
3. Remove blown fuse and replace with a good fuse of the same type and rating.
4. Screw the fuse holder cap back in place and reconnect power
4.2 Cleaning
Due to fog residue, smoke, and dust cleaning the internal and external optical
lenses must be carried out periodically to optimize light output.
1. Use normal glass cleaner and a soft cloth to wipe down the outside casing.
2. Clean the external optics with glass cleaner and a soft cloth.
3. Always be sure to dry all parts completely before plugging the unit back in.
Cleaning frequency depends on the environment in which the fixture operates
(i.e. smoke, fog residue, dust, dew).
4.3 Trouble Shooting
1. Unit does not respond to DMX:
Check that the DMX cables are connected properly and are wired correctly (pin 3
is “hot”; on some other DMX devices pin 2 may be ‘hot’). It does matter which
way the inputs and outputs are connected.
Disconnect from mains before servicing.
