4/11
©
PHANTOS
®
Distributed in Australia by PHANTOS www.phantos.com.au
2.2.1 Line Termination
In DMX Mode, at the last fixture in the chain, the DMX output has to be
connected with a DMX terminator. This prevents electrical noise from
disturbing and corrupting the DMX control signals. The DMX terminator is
simply an XLR connector with a 120
(ohm) resistor connected across pins 2
and 3, which is then plugged into the output socket on the last projector in
the chain. The connections are illustrated below.
2.3 AC Power
This product has an auto-ranging power supply that can work with an input
voltage range of 100~240 VAC, 50/60 Hz.
Warning!!! All fixtures must be connected to circuits with a
suitable Earth Ground.
5/11
©
PHANTOS
®
Distributed in Australia by PHANTOS www.phantos.com.au
3 OPERATION INSTRUCTIONS
3.1 Menu Map
Display
Function
d001-d512
DMX mode, 6CH
CC00-CC99
Color macro 1
CP00-CP99
Color macro 2
dE00-dE99
Color macro 3
dEdF
Master mode
--on--
Display on (--oFF, Display off)
O000-O255
White Dimmer
Y000-Y255
Amber Dimmer
3.2 Auto Mode
In this mode, you can set the unit to run in static colors, strobe, or do color
changing without a DMX controller.
1
. Press
MENU
button until display reads:
“ CCxx ”, “CPxx” or “dExx”.
2. Press ENTER button and use UP/DOWN button to select number from 00-99
to adjust running speed from slow to fast.
3.3 DMX Mode
In DMX mode, you can control the fixture with a DMX controller.
1. Press
MENU
button until display reads
: “ dxxx ” for DMX mode.
2. Then press ENTER button and use Up/Down button to set DMX address for the
fixture.
