aterMark
W
aterMark
W
TM
pH MIRACLE
THE
®
9
terMark. Be sure to push in the tube all the way. Also be sure any cut ends of the tubing are cut
square and not flattened. If fitting leaks once water is turned on then remove tubing, re-cut end
and re-insert.
11. The under sink installation of the WaterMark is now complete. Before turning on the water
supply, make sure the faucet on the WaterMark and the Accessory Faucet are in the off position—
handle pointing up.
12. Now turn on the water supply at the cold water shut off valve. At this time, if any water is com-
ing from either the WaterMark faucet or the new accessory faucet turn them off. Dry any water that
has leaked or splashed. Inspect all connections for leaks, if unsure about a possible leak, dry the
area with a paper towel and inspect again.
13. If you see any leaks shut off the water supply at the cold water shut off valve.
Open Accessory Faucet to relieve any pressure in the unit. Remove leaking tube and inspect end is
cut square and not at an angle. If cut at an angle, re-cut it square and be sure the end is round when
inserting tube into connector.
(If you need to remove the tube, here is a note about Quick Connect Fittings: to remove the
tube from a Quick Connect, water supply must be off and pressure must be relieved from
the WaterMark. You will see a round collar to the outside of the Quick Connect Fitting, this
collar must be pushed in towards the connector and held in as you pull the tubing out. You
may use your fingernail or the Quick Connect Release Tool to push in on the collar. If the col-
lar is not pressed and held in while pulling on the tubing, the tubing will not be removable.)
14. Once you confirm there are no leaks on the back of WaterMark and at the Accessory Faucet
connection where tube enters faucet, then you may open the Accessory Faucet above the sink and
let water run through the WaterMark.
15. On first use, allow the water to run through the WaterMark for at least ten minutes to flush
the filters out (the water may appear discolored in the beginning). After the 10 minutes passes the
water is ready for drinking.
16. Ensure that the faucet on the actual WaterMark appliance stays closed or water will be dis-
pensed below your sink. You may want to tape the handle of the WaterMark faucet closed so it
cannot be opened accidentally.
17. Go to Section #6 for Usage Instructions. Refer to Section #5 for Troubleshooting if you have any
problems or if the unit is not working correctly.
