aterMark
W
aterMark
W
TM
pH MIRACLE
THE
®
5
faucet Diverter, this will prevent leaks. Screw the Diverter onto the faucet hand tight, no need to use
tools. (After the final step, if you see a leak then you may use pliers to turn the Diverter one more
half turn until leak stops.)
5. Place the WaterMark on the level surface where you intend for it to stay. Decide how long the tubing
needs to be to easily reach from the faucet to your WaterMark. You may gather the tubing and hide it
behind the WaterMark or cut the tubing to desired length using scissors or a utility knife. Do not cut the
tubing at an angle. Also be sure to leave enough tubing to allow you to easily swivel your faucet either
direction once attached.
6. Take the free end of the tubing and press it onto the barbed end of the faucet Diverter. Be sure to
push the tubing completely over the barbs.
If there is no barbed end but a nut instead, remove the nut on the Diverter. Slip the nut over the end of
the tube and push that end onto the Diverter, over the barb revealed once you removed the nut. When
the tube is well seated, screw the nut back on to hold it in place.
7. Now install the Faucet Spout. Verify that the two rubber ‘O’ rings are on the bottom of the shaft. Use
olive or cooking oil to lightly coat the ‘O’ rings, then press the Spout firmly into the open hole on the
WaterMark until the both ‘O’ rings are concealed.
8. Notice the lever on the side of the Diverter. When the lever is down the water will flow through the
Diverter into your sink. When the lever is turned up, the water is redirected to run through your Water-
Mark.
Turn on the water at your main faucet. Move the lever on the Diverter up to send the water through
the WaterMark. It may take a few seconds for the water to exit the WaterMark, this is normal as all the
filters fill with water.
9. On first use, allow the water to run through the WaterMark for at least ten minutes to flush the filters
out (the water may appear discolored in the beginning). After the 10 minutes passes the water is ready
for drinking.
CONGRATULATIONS,
YOU HAVE SUCCESSFULLY INSTALLED YOUR WATERMARK.
10. Go to Section #6 for Usage Instructions. Refer to Section #5 for Troubleshooting if you have any
problems or if the unit is not working correctly.
