ENGLISH
ENGLISH
13
14
15
MAINTENANCE & CARE
12
FAUCET FUNCTION
CAUTION: Maintenance
DISASSEMBLY
1. Replacement parts may be available at the store where you purchased
your faucet.
2. When replacement parts are not available, please write or call Pfister
Consumer Service.
3.
Always turn off water and relieve pressure before working on your
faucet.
NOTE: Trim Care
Cleaning Instructions:
For all Handles and decorative finishes, use only a soft damp
cloth to clean and shine. Use of polish, detergents, abrasive
cleaners, organic solvents or acid may cause damage.
Use of
other than a soft damp cloth will nullify our warranty!
Special Trim:
Trim products which contain Porcelain or other similar
substance are not acceptable for public areas or Commercial
use. Installation of Said Trim is at Users Risk!
1–800–PFAUCET (1–800–732–8238)
For Toll-Free Pfaucet information call
1–800–PFAUCET (1–800–732–8238)
or visit www.pfisterfaucets.com
• Installation Support
• Care and Warranty Information
14 HANDLE REMOVAL
Turn off water before proceeding.
Carefully pry off Handle Button (
14A
) using a
small screwdriver or blade. Using a
3/32
” Allen wrench, loosen Set Screw (
14B
) and
remove Handle (
14C
).
13 FLUSHING & AERATOR CLEANING
After installation is complete, remove Aerator Housing (
13A
). Lift Handle (
13B
) on
and allow both hot and cold water to run for at least one minute each. While water is
running, check for leaks. To clean the aerator, disassemble Aerator Housing (
13A
) by
separating the Aerator Shell (
13C
), Basket (
13D
), and Washer (
13E
). Once parts have
been cleaned, reassemble by reversing steps.
15 CARTRIDGE REPLACEMENT
Turn off water supplies and relieve pressure before working on your faucet.
Remove
handle (
see figure 14
). Remove the Dome Cap (
15A
) by unscrewing counterclockwise.
Using an
adjustable wrench
, unscrew the retainer ring (
15B
). Carefully remove the
Cartridge (
15C
) by pulling it straight up and out. Reassemble valve by reversing steps.
12 VALVE FUNCTION
By lifting the Lever Handle (
12A
) up, the valve will be activated allowing water to flow.
The water flow will increase by continuing to lift up the Lever Handle (
12A
). By rotating
the Lever Handle counter-clockwise, the water temperature will decrease to cold flow
only. By rotating the Lever Handle clockwise, the water temperature will increased to
hot flow only.
Note: Flush faucet before turning on valve (
see step 13
).
4
13E
13D
13C
13A
13B
14A
14B
14C
15A
15B
15C
12A
HOT
COLD
OPEN
12A
Summary of Contents for PARISA LG42 Series
Page 11: ...FRANÇAIS FRANÇAIS 11 ...
