EN – 13
EN
Maintenance
Cleaning components
Cleaning metal
components
Cleaning the oil level
sight glass
I, SD, SDI, C2 series pumps
Solvents are required to clean components.
Standard precautions should be taken in compliance with the manufacturer's
instructions.
After use in mineral or synthetic oil
, clean the metal components with a mineral
products based solvent such as
AXAREL
(1)
,
CARECLEAN
(2)
,
PREMACLEAN
(3)
,
NAPHTESOL
(4)
. Proceed as follows:
• Clean when cold or hot (max. 45 °C) by dipping or using a cloth
• Vacuum dry in a ventilated oven
• The component must be cleaned a second time with alcohol.
After use in (perfluorinate) synthetic oil
, clean the metal components in a solvent
such as
GALDEN S 90
™
(5)
and proceed as follows:
• Clean when cold by dipping or using a cloth
• Dry the components in the air or with compressed air
After use in (non-perfluorinate) synthetic or mineral oil,
clean the metal
components with a solvent such as alcohol and proceed as follows:
• Clean when cold by dipping or using a cloth
• Dry the components in the air
• Industrial washing solutions can also be used. The cleaning operation should be
followed by vacuum drying.
When cleaning this plastic sight glass, avoid contact with alcohol or alcohol-based
washing solutions. Clean the component with a solvent, but do not steep it, and rinse
it immediately.
The sight glass of these pumps is made of glass: it can be cleaned with common used
solvents.
(1) DUPONT DE NEMOURS registered trademark
(2) CASTROL registered trademark
(3) DOW registered trademark
(4) Nippon Oil Corporation registered trademark
(5) MONTEDISON registered trademark
C1 series pumps
