Pfaff 3566-2/02, Instruction Manual, Page: 37 / 58

10 - 8
Programming
5 - INDICATION OF INPUTS
When this function is enabled the conditions of the inputs are indicated from left to
right. The sequence corresponds with the arrangement of the luminous diodes on the
terminal strip, beginning at terminal 1.
1 = diode on (low signal) / 0 = diode off (high signal)
Terminal Input board Input Input signal
1 A26 E1.1 Guide blade back
2 E1.2 Guide blade forward
3 E2 Guide blade right
4 E1.3 Guide bladE middle (with feed table)
5 - free
6 E11 Small-part stop forward
7 - free
8 - free
9 E20.1 Foot switch, 1st posn. (without feed table)
10 E20.2 Foot switch, 2nd posn. (without feed table)
11 E30 Basic posn., workpiece retainer (X-axis)
12 E31 Basic posn., angle seam (Y-axis)
13 E19 Work holder monitor
14 E21 Suction off (with feed table)
15 - free
16 - free
17 E18 Needle thread monitor
18 BOBERR Bobbin thread error
19 V12TST Voltage 12V in order
20 SMALL Small parts
21 TABE Feed table fitted
22 SMY Stepping motor for angle seam (y-axis)
23 - free
24 COSTEN cold start