Pfaff 2481-980/30 PLUSLINE, Instruction Manual, Page: 55 / 112

Adjustment
13 - 1
13 Adjustment
No C-clamp should be fastened to the needle bar of the PFAFF 2481-980/30.
This could cause damage to the special coating of the needle bar.
13
.01
Notes on adjustment
All following adjustments are based on a fully assembled machine and may only be carried
out by expert staff trained for this purpose.
Machine covers, which have to be removed and replaced to carry out checks and
adjustments, are not mentioned in the text.
The order of the following chapters corresponds to the most logical work sequence for
machines which have to be completely adjusted. If only specific individual work steps are
carried out, both the preceding and following chapters must be observed.
Screws, nuts indicated in brackets ( ) are fastenings for machine parts, which must be
loosened before adjustment and tightened again afterwards.
Unless stated otherwise, during all adjustment work the machine must be
disconnected from the electric and pneumatic power supply!
Danger of injury if the machine is started accidentally!
13
.02
Tools, gauges and other accessories for adjusting
●
1 set of screwdrivers with blade widths from 2 to 10 mm
●
1 set of wrenches with jaw widths from 7 to 14 mm
●
1 set of Allan keys from 1.5 to 6 mm
●
1 metal rule, (Part No. 08-880 218-00)
●
1 feed dog adjustment gauge, Part No. 61-111 639-71
●
1 adjustment pin (5 mm dia.), Part No. 13-033 346-05
●
1 adjustment gauge for tightening the belt of the hook drive, part no. 61-111 639-76
●
Adjustment gauge, part No. 61-111 639-73
●
Sewing thread and test material
13
.03
Abbreviations
TDC = top dead center
BDC = bottom dead center