12.
OWNER OPERATING INSTRUCTIONS
FOR YOUR SAFETY
WARNING
If you smell gas
:
Improper installation, adjustment, alteration,
1. Open windows
service or maintenance can cause injury or
2. Do not touch electrical switches
property damage. Refer to the burner manual for
3. Extinguish any open flame
assistance or additional information consult
4. Call you gas supplier immediately
a qualified installer, service agency or the gas
supplier.
Do not store or use gasoline or other flammable liquids and vapors in the vicinity of this or any other
appliance.
IMPORTANT PRECAUTIONS
1. Never attempt to light burner with paper or
other materials.
2. Never experiment with t he burner.
3. Never change the fuel or air adjustments
without consulting with the burner service
company.
4. Never attempt to light the burner if
combustion chamber contains any unburned
fuel or gases.
5. Never throw waster paper, rags, garbage or
other waster materials into the combustion
chamber.
6. Never wash out heating equipment room
without first covering the burner with
waterproof material.
START UP
Preparation for Start Up
1.
Ensure that the system is in working order. If
heat exchanger is a boiler, ensure that proper
water level is available.
2.
Set the burner control panel switch to the OFF
position.
3. Turn the thermostat or operating control down
to its lowest setting.
4. Check fuses and replace as necessary.
5. Depress the flame safeguard programming
control reset button.
Start Up
1. Manually open and close the main gas shut
off cock, leak test cock and pilot cock to
determine that they operate freely. Open all
three cocks. (Reset low gas pressure switch
if supplied).
2. Set the main power switch and burner panel
control switch to the ON position. Wait 30
seconds and turn up thermostat or operating
control to the desired setting.
3. The burner blower motor will start and after a
suitable pre-purge period (this will vary with the
type of flame safeguard control supplied – but
will usually be minimum of 30 seconds to a
maximum of 90 seconds) the burner pilot will
light, after which the main flame will be
established.
4.
If the system does not respond properly, contact
your qualified burner service company.
EXTENDED SHUT DOWN
1.
Place main power switch and burner control panel switch in the OFF position.
2.
Close all valves in gas lines. Cover burner to protect it from dust and dampness.
3.
Cover burner to protect it from dust and dampness.
MAINTENANCE
Burner should be maintained and serviced by a qualified service agent. See service and maintenance
section of the manual for suggestions on periodic maintenance and service
.
Summary of Contents for X4-400
